Diagnostic Test

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY IF DTC B1DF2-MIRROR FOLD SWITCH STUCK IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, erase all DTC's.
3. Press the Mirror Fold Switch in all directions several times.
4. Cycle the ignition from on to off 3 times.
5. Turn the ignition on.
6. With the scan tool, read DTC's.
  Does the scan tool display active: B1DF2-MIRROR FOLD SWITCH STUCK?
  
  Yes
  - Replace the Drivers Door Window/Mirror Switch Assembly in accordance with the Service Information.
  - Perform BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
  - Perform BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .