Troubleshooting Tools
When diagnosing a problem in an electrical circuit there are several common tools necessary. These tools are listed and explained below.
- Jumper Wire - This is a test wire used to connect two points of a circuit. It can be used to bypass an open in a circuit.
Never use a jumper wire across a load, such as a motor, connected between a battery feed and ground.
- Voltmeter - Used to check for voltage on a circuit. Always connect the black lead to a known good ground and the red lead to the positive side of the circuit.
Most of the electrical components used in today's vehicles are Solid State. When checking voltages in these circuits, use a meter with a 10 - megohm or greater impedance rating.
- Ohmmeter - Used to check the resistance between two points of a circuit. Low or no resistance in a circuit means good continuity.
Most of the electrical components used in today's vehicles are Solid State. When checking resistance in these circuits use a meter with a 10 - megohm or greater impedance rating. In addition, make sure the power is disconnected from the circuit. Circuits that are powered up by the vehicle's electrical system can cause damage to the equipment and provide false readings.
| 1 - SPECIAL TOOL 6801 |
| 2 - PROBING END |
- Probing Tools - These tools are used for probing terminals in connectors. Select the proper size tool from Special Tool Package (special tool #6807, Terminal Tools), and insert the probing end (2) into the terminal being tested. Use the other end of the tool (1) to insert the meter probe.