LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2013 >> Compass Limited, AWD, Trans Mfr CD CVT2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Rear Driveline Module) >> Installation >> Installation

Section 78 (Rear Driveline Module): Installation: Installation

WARNING: This page is about a different car, the 2012 Jeep Patriot and 2012 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Axle Remove And Install
GC0098398Courtesy of CHRYSLER GROUP, LLC
  1. Install the ECC to the RDA.
  2. Install the ECC bolts and tighten to 68 N.m (50 ft. lbs.).
  3. Lift driveline module (1) with a transmission jack (3) while installing both axles. Refer to Fig 1.
    Fig 2: Electrical Connector
    GC0083873Courtesy of CHRYSLER GROUP, LLC
  4. Connect breather hose to ECC.
  5. Connect the electrical connector (1).
  6. Install wire harness bracket and two mounting bolt and tighten to 10 N.m (89 in. lbs.).
    Fig 3: Rear Axle Remove And Install
    GC0098398Courtesy of CHRYSLER GROUP, LLC
  7. Lift driveline module (1) into place.
    Fig 4: Driveline Module Mounting Bolts
    GC0083872Courtesy of CHRYSLER GROUP, LLC
  8. Install the two driveline module side mounting bolts (1) and tighten to 102 N.m (75 ft. lbs.). Refer to Fig 4.
    Fig 5: Rear Bolt AT Axle
    GC0083871Courtesy of CHRYSLER GROUP, LLC
  9. Install the one rear driveline module mounting bolt (1) and tighten to 102 N.m (75 ft. lbs.). Refer to Fig 5.
    Fig 6: Right Stay Bar
    GC0098397Courtesy of CHRYSLER GROUP, LLC
  10. Install right side stay bracket and tighten bolts (1) to 61 N.m (45 ft. lbs.). Refer to Fig 6.
    Fig 7: Left Side Stay Bar
    GC0083870Courtesy of CHRYSLER GROUP, LLC
  11. Install left side stay bracket and tighten bolts (1) to 61 N.m (45 ft. lbs.). Refer to Fig 7.
  12. Install the propeller shaft. Refer to INSTALLATION .
  13. Fill the rear axle with fluid.
    Fig 8: Sway Bar
    GC0098396Courtesy of CHRYSLER GROUP, LLC
  14. Roll sway bar (2) into place (if equipped). Refer to Fig 8.
    Fig 9: Left Side Sway Bar Nut
    GC0083869Courtesy of CHRYSLER GROUP, LLC
  15. Install left side sway bar nut (1) (if equipped) and tighten to (61 N.m (45 ft. lbs). Refer toFig 9.
    Fig 10: Right Sway Bar Nut
    GC0083868Courtesy of CHRYSLER GROUP, LLC
  16. Install right side sway bar nut (1) (if equipped) and tighten to 61 N.m (45 ft. lbs). Refer toFig 10.
  17. Install the exhaust. Refer to MUFFLER, EXHAUST, INSTALLATION .
  18. Install the wheels. Refer to DIAGNOSIS AND TESTING .
scientia non olet · About LEMON Manuals