SENSOR, Intrusion Module: Installation: Receiver
WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Position the intrusion sensor receiver (1) to the mounting bracket (4) on the right front corner of the overhead console housing (3).
- Press the receiver down until the three latch features (2) of the bracket are fully engaged.
- Reconnect the take out of the overhead wire harness to the connector receptacle (5) on the rearward end of the receiver housing.
- Reinstall the overhead console onto the headliner. Refer to Electrical/Overhead Console - Installation .
- Reconnect the battery negative cable.