Connector Terminal Removal

WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

1 - DRESS COVER

2 - CONNECTOR LOCK

3 - CONNECTOR

Disconnect battery.
Release Connector Lock (2).
Disconnect the connector (3) being repaired from its mating half/component.
Remove the dress cover (if applicable) (1).

Courtesy of CHRYSLER GROUP, LLC

1 - Secondary Terminal Lock

Release the Secondary Terminal Lock, if required (1).

Courtesy of CHRYSLER GROUP, LLC

1 - TYPICAL CONNECTOR

2 - PICK FROM TERMINAL REMOVER KIT 10300

3 - APEX CONNECTOR

4 - PICK FROM TERMINAL REMOVER KIT 10300

5 - AUGAT CONNECTOR

6 - ELECTRICAL TERMINAL REMOVAL TOOL

7 - MOLEX CONNECTOR

8 - PICK FROM TERMINAL REMOVER KIT 10300

9 - THOMAS AND BETTS CONNECTOR

10 - TERMINAL REMOVER

11 - CONNECTOR

12 - ELECTRICAL TERMINAL REMOVER

Position the connector locking finger away from the terminal using the proper special tool. Pull on the wire to remove the terminal from the connector.