Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR TIPM CAN BUS DTCS
- With the scan tool, read TIPM DTCs.
Are there any TIPM CAN BUS DTCS present?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
- Refer to STANDARD PROCEDURE and perform the NAG1 TRANSMISSION VERIFICATION TEST.
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the Service Information.
- Refer to STANDARD PROCEDURE and perform the NAG1 TRANSMISSION VERIFICATION TEST.
- With the scan tool, read TIPM DTCs.