Steering System: Gear: Installation: Installation

Fig 1: Steering Gear Mounting Bolts

Courtesy of CHRYSLER GROUP, LLC

Install the steering gear on the frame rail and tighten the bolts (1) to 118 N.m (87 ft. lbs.)

Fig 2: Pitman Arm Nut
Courtesy of CHRYSLER GROUP, LLC
Align and install the pitman arm (2) and tighten the nut (3) to 265 N.m (195 ft. lbs.).

Fig 3: Track Bar Frame Side
Courtesy of CHRYSLER GROUP, LLC

NOTE:
It may be necessary to pry the axle assembly over to install the track bar (1) at the frame rail.
Position the track bar (1) at the axle bracket, install the nut and bolt (2) at the frame rail bracket and tighten to 169 N.m (125 ft. lbs.).
Remove the support and lower the vehicle.

Fig 4: Lower Coupling At Gear
Courtesy of CHRYSLER GROUP, LLC
Align the column coupler shaft (1) to the steering gear (2). Install a new coupler pinch bolt and tighten to 49 N.m (36 ft. lbs.).

Fig 5: Steering Gear Hoses/Tubes
Courtesy of CHRYSLER GROUP, LLC
Install the power steering hoses/tubes (1, 2) to the steering gear and tighten to 28 N.m (21 ft. lbs.).
Reinstall the coolant bottle back into position.
Fill the power steering system to the proper level. Refer to STANDARD PROCEDURE .
Check the toe setting. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .