LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Final Drive Control >> Removal >> Removal

Module, Final Drive Control: Removal: Removal

NOTE:

The FDCM has two electrical connectors and is installed inside the passenger compartment behind the driver side knee bolster and is mounted to the left kick panel. On RHD vehicles the FDCM is located in a mirrored position on the right side.

Fig 1: Final Drive Control Module
GC0086446Courtesy of CHRYSLER GROUP, LLC
  1. Lower the drivers side knee bolster.
  2. Push out on the two locking tabs (1) and remove the FDCM.
    Fig 2: FDCM Electrical Connectors
    GC0086447Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the two electrical connectors (1) from the FDCM.
scientia non olet · About LEMON Manuals