Switch, Washer Fluid Level: Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The washer fluid level switch may be removed from the washer reservoir without removing the reservoir from the vehicle.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Turn the steering wheel to move the front wheels to the full right turn position.
Raise and support the vehicle.
Remove the fasteners that secure the forward end of the right front wheel house splash shield to the inner fender panel and the front fascia. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Pull the forward end of the splash shield away from the inner fender panel and front fascia far enough to access the washer fluid level switch (3) on the washer reservoir (4) on the outboard side of the right frame rail.
Disconnect the headlight and dash wire harness (1) connector for the washer fluid level switch (6) from the switch connector receptacle.
Disconnect the washer hose (2) from the barbed outlet nipple of the washer pump and allow the washer fluid to drain into a clean container for reuse.
Using hand pressure, firmly grasp and pull the washer fluid level switch outward far enough to disengage the barbed switch nipple from the rubber grommet seal in the reservoir. Care must be taken not to damage the reservoir.
Remove the washer fluid level switch from the washer reservoir.
Remove the rubber grommet seal from the washer fluid level switch mounting hole in the reservoir and discard.