LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 692 (Cooling System) >> Engine >> Fan, Cooling >> Removal >> 5.7/6.4L Single Fan

5.7/6.4L Single Fan

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0144488Courtesy of CHRYSLER GROUP, LLC
NOTE:

If replacing the fan blades. The dual fan blades can be replaced separately from the motor. Single motor fan blades are balanced to the motor and must be replaced as a fan/motor assembly.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body. Refer to REMOVAL .
  3. Disconnect the cooling fan wire harness connector (1).
  4. Remove the upper cooling fan mounting bolts (3).
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  7. Loosen  the lower radiator support bolts.
    GC0144486Courtesy of CHRYSLER GROUP, LLC
  8. Remove the radiator cooling fan assembly (1) from the radiator by pushing up and away from the radiator mounts.
  9. While moving the lower core support forward, slowly lower the left side of the cooling fan assembly from the bottom of the vehicle.
  10. Remove the cooling fan assembly.
scientia non olet · About LEMON Manuals