Sensor, Oxygen: Removal: 3.6L: Upstream
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The exhaust pipes and catalytic converter become very hot during engine operation. Allow the engine to cool before removing the oxygen sensor.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE
.CAUTION:
When disconnecting the oxygen sensor electrical connector, do not pull directly on the wire going into the sensor. The sensor wiring can be damaged resulting in sensor failure.
- Disconnect the oxygen sensor wire harness connector (1).
- Disengage the oxygen sensor wire harness (4) from the retainer (2).
- Remove the oxygen sensor (3).
- Clean the exhaust pipe threads using an appropriate tap.