Camera, Rear: Removal: Bezel
WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Rear View Camera (RVC) is secured by screws to the back of the camera bezel and may be serviced without disturbing the bezel. The camera bezel is secured to the outer surface of the deck lid by an adhesive membrane and must be replaced with a new bezel and adhesive membrane unit if damaged or removed from the deck lid.
- Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
- Working from the inside of the deck lid (1), remove the Rear View Camera (RVC) (2) from the back of the camera bezel (3). Refer to CAMERA
.NOTE:
During the following operations take the appropriate precautions to prevent cosmetic damage to the paint finish of the deck lid.
- Working carefully from the outside of the deck lid, disengage the adhesive membrane of the bezel from the deck lid.
- Remove the bezel from the deck lid and discard.