Module, Radio Frequency (RF Hub): Installation: Installation
WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace and Program the module(s) per the RF-Hub, BCM, PCM FOBik and ELV Replacement and Programming Order Guide. Refer to STANDARD PROCEDURE .
- Position into place and install the RF Hub (4) and retainers (1).
- Connect the electrical connectors (2).
- If equipped, connect the remote start antenna (3).
- Install the rear shelf cover. Refer to PANEL, REAR SHELF, INSTALLATION .
- Connect the Intelligent Battery Sensor (IBS) to the negative battery post.
NOTE:
Program the RF-Hub. Refer to STANDARD PROCEDURE .