Diagnostic Test

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR AN INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Cycle the Driver Seat Switch in all directions several times.
4. Wait one minute.
5. With the scan tool, read the active DTCs.
  Does the scan tool display B1D62-2A-POWER SEAT SWITCH STUCK-STUCK?
  
  Yes
  - Replace the Driver Seat Switch in accordance with the Service Information.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE - POWER SEAT SYSTEM VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagram as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE - POWER SEAT SYSTEM VERIFICATION TEST .