LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Chime/Buzzer/Driver Assist (Service Information)) >> Sensor, Blind Spot >> Removal

Sensor, Blind Spot: Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
  2. Remove the rear bumper fascia from the vehicle. Refer to FASCIA, REAR, REMOVAL .
    GC0184087Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Left Blind Spot Sensor (LBSS) or Right Blind Spot Sensor (RBSS) wire harness connector (3).
  4. Disengage the latch tab (2) of the blind spot sensor bracket and pull the LBSS or RBSS (1) out of the bracket.
scientia non olet · About LEMON Manuals