Manual Bleeding Method: Notes

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

To bleed the base brake system manually, an assistants help is required.

Fig 1: Vehicle Rear Raised For Bleeding

Courtesy of CHRYSLER GROUP, LLC

NOTE:

To ensure all air is bled from the ICU or junction block in a timely manner, it is recommended to raise the rear of the vehicle approximately 5° higher than the front or approximately 10-12 inches as measured at the rear bumper (1).

Raise and support vehicle placing rear of vehicle approximately 5° higher than the front or if measured at the rear bumper (1), approximately 10-12 inches above level. It will be necessary to add extra support stands under vehicle to support this angle.

NOTE:

The following wheel circuit sequence for bleeding the brake hydraulic system should be used to ensure adequate removal of all trapped air from the brake hydraulic system.

Right rear wheel
Left rear wheel
Right front wheel
Left front wheel