LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 700 (Steering System) >> Column >> Wheel, Steering >> Removal

Wheel, Steering: Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0162414Courtesy of CHRYSLER GROUP, LLC
WARNING:

Before servicing the steering column, the airbag system must be disarmed. Refer to electrical restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag and possible personal injury.

  1. Position the front wheels straight-ahead  .
  2. Fully extend the adjustable steering column.
  3. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  4. Remove the driver airbag. Refer to AIR BAG, DRIVER, REMOVAL .
  5. Disconnect all wire harness connectors (3).
  6. Remove and discard the steering wheel bolt (2) and then slide the steering wheel (1) off the shaft.
  7. If the wheel is being replaced, transfer attached components as necessary.
scientia non olet · About LEMON Manuals