Section 70 (Engine Cooling System): Engine: Thermostat: Installation: 3.0L
WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The Thermostat and housing is serviced as an assembly. Do not remove the thermostat from the housing, damage to the thermostat may occur.
- Install a new seal on to the thermostat housing.
- Position thermostat housing (2) onto the water pump.
- Install two thermostat housing bolts (1). Tighten bolts to 11 N.m (97 in. lbs.).
- Install upper radiator hose on thermostat housing (2).
- Fill cooling system. Refer to STANDARD PROCEDURE .
- Install the air intake system. Refer to BODY, AIR CLEANER, INSTALLATION or BODY, AIR CLEANER, INSTALLATION, 5.7L or BODY, AIR CLEANER, INSTALLATION .
- Connect negative battery cable to battery.
- Start and warm the engine. Check for leaks.