5.7L Single Fan
WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If replacing the fan blades. The dual fan blades can be replaced separately from the motor. Single motor fan blades are balanced to the motor and must be replaced as a fan/motor assembly.
CAUTION:
When installing the cooling fan assembly. Care must be used so that the fan shroud does not contact the radiator or the radiator fins. Damaged may cause leaking.
- Install the radiator cooling fan assembly (1) in vehicle.
- Align the lower cooling fan assembly mounting tabs (1) with the radiator mounts (2).
- Tighten the lower radiator support bolts to the proper specification. Refer to SPECIFICATIONS .
- Install the lower engine belly pan. Refer to BELLY PAN, INSTALLATION .
- Remove support and lower vehicle.
- Install the cooling fan assembly mounting bolts (3). Tighten to the proper specification. Refer to SPECIFICATIONS .
- Connect cooling fan wire harness connector (1).
- Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION, 5.7L .
- Connect the negative battery cable.
- Operate engine until it reaches normal operating temperature. Check the fan for proper operation.