LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 508 (Ignition System (Service Information)) >> Sensor, Knock >> Installation >> 6.2L

Sensor, Knock: Installation: 6.2L

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Knock Sensor
GC0080083Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Over or under tightening the knock sensor mounting bolts will affect knock sensor performance, possibly causing improper spark control.

  1. Install the knock sensor (1) onto the cylinder block.
  2. Tighten the bolt (2) to the proper specification. Refer to TORQUE SPECIFICATIONS .
  3. Connect the knock sensor wire harness connector (5).
    Fig 2: Knock Sensor Heat Shield
    GC0080084Courtesy of CHRYSLER GROUP, LLC
  4. Snap the heat shield (1) onto the knock sensor.
    Fig 3: Lower Splash Shield & Fasteners
    GC0095584Courtesy of CHRYSLER GROUP, LLC
  5. Install the lower splash shield and securely tighten the fasteners (1).
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals