Cruise Mode
WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
When the engine is at operating temperature, this is a Closed Loop mode. At cruising speed, the PCM receives inputs from:
- Air conditioning select signal (if equipped)
- Air conditioning request signal (if equipped)
- Battery voltage
- Camshaft Position Sensor (CPS) signal
- Engine Coolant Temperature (ECT) sensor
- Intake Manifold Air Temperature (MAT) sensor
- Manifold absolute pressure (MAP) sensor
- Accelerator Pedal Position Sensor (APPS)
- Throttle position sensors (TPS)
- Crankshaft Position (CKP) sensor
- Battery voltage
- Park/neutral switch (gear indicator signal)
- Oxygen (O2) sensors
Based on these inputs, the following occurs:
- Voltage is applied to the fuel injectors with the ASD relay via the PCM. The PCM will then adjust the injector pulse width by turning the ground circuit to each individual injector on and off.
- The PCM monitors the O2S sensor input and adjusts air-fuel ratio.
- The PCM adjusts ignition timing by turning the ground path to the coils on and off.
- The PCM operates the A/C compressor clutch through the clutch relay. This happens if A/C has been selected by the vehicle operator and requested by the A/C thermostat.