Section 304 (Steering System): Gear: Installation: 2WD
WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Transfer the outer tie rod ends to the new steering gear (if needed).
- Install the steering gear (1) to the vehicle.
- Install the gear mounting bolts (2) to the front cradle. Tighten the gear mounting bolts to 176 N.m (130 ft. lbs.).
- Install the power steering lines (1, 2) to the gear (1). Tighten the tube nuts to 27 N.m (20 ft. lbs.).
- Install the lower coupler pinch bolt and slide the coupler on to the gear. Tighten to 53 N.m (39 ft. lbs.).
- Install the tie rod end to the knuckle and tighten the nuts to 41 N.m (30 ft. lbs.) Plus an additional 90° turn.
- Install the tire and wheel assembly. Refer to WHEELS, STANDARD PROCEDURE .
- If equipped, install the skid plate.
- Remove the support and lower the vehicle.
- Unlock the steering wheel.
- Fill the power steering fluid. Refer to STANDARD PROCEDURE .
- Reset the toe and center the steering wheel. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .