Section 227 (Circuit Testing Procedures - Non-DTC-Based Diagnostics): Removal: Removal

WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removal Of Dress Cover

Courtesy of CHRYSLER GROUP, LLC

1 - DRESS COVER

2 - CONNECTOR LOCK

3 - CONNECTOR

Disconnect battery.
Release Connector Lock (2).
Disconnect the connector (3) being repaired from its mating half/component.
Remove the dress cover (if applicable) (1).

Fig 2: Connector Secondary Terminal Lock
Courtesy of CHRYSLER GROUP, LLC

1 - Secondary Terminal Lock

Release the Secondary Terminal Lock, if required (1).

Fig 3: Terminal Removal

Courtesy of CHRYSLER GROUP, LLC

1 - TYPICAL CONNECTOR

2 - PICK FROM TERMINAL REMOVER KIT 6680 OR 8197A

3 - APEX CONNECTOR

4 - PICK FROM TERMINAL REMOVER KIT 6680 OR 8197A

5 - AUGAT CONNECTOR

6 - ELECTRICAL REMOVER 6932

7 - MOLEX CONNECTOR

8 - PICK FROM TERMINAL REMOVER KIT 8197A

9 - THOMAS AND BETTS CONNECTOR

10 - TERMINAL REMOVER 6934

11 - TYCO CONNECTOR

12 - ELECTRICAL TERMINAL REMOVER 8638

Position the connector locking finger away from the terminal using the proper special tool. Pull on the wire to remove the terminal from the connector.