LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 191 (Electronic Control Modules (Service Information)) >> Module, Integrated Center Stack Screen >> Removal >> Base

Module, Integrated Center Stack Screen: Removal: Base

WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Instrument Cluster Bezel Retainer & Bezel
GC0145130Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the instrument cluster bezel retainer (1) and remove the bezel (2). Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
    Fig 2: Harness Connectors & Integrated Center Stack (ICS) Screen Module
    GC0144619Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the harness connectors (2 & 3) from the rear of the Integrated Center Stack (ICS) screen module (1) to allow better access to the 40 - way connector.
    CAUTION:

    Push the 40 way connector in before pushing on the locking clip. Failure to follow these instructions will damage or break the connector locking clip.

    Fig 3: Way Connector
    GC0144026Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    In the event that the locking tab breaks or is broken, do not replace the harness. The connector will still lock and the harness will still function as designed.

    CAUTION:

    Never pull the connector out by the wires. Failure to follow these instructions will damage or break the wires and/or connector.

  4. Push in on the 40 - way connector (1).
    Fig 4: Connector Release Lock
    GC0144025Courtesy of CHRYSLER GROUP, LLC
  5. Gently push down on the connector release lock (1).
    Fig 5: Screw Driver & Connector
    GC0144617Courtesy of CHRYSLER GROUP, LLC
  6. Using a pocket screw driver or a trim stick (special tool #C-4755, Trim Stick) or equivalent (1), gently pry on one side of the connector (2).
    Fig 6: Screw Driver & Connector
    GC0144618Courtesy of CHRYSLER GROUP, LLC
  7. Using a pocket screw driver or a trim stick (special tool #C-4755, Trim Stick) or equivalent (1), gently pry on the other side of the connector (2).
  8. Use steps 7 and 8 until the connector is out far enough to grab the connectors with your fingers.
    Fig 7: Retainers
    GC0145110Courtesy of CHRYSLER GROUP, LLC
  9. Remove the retainers (1) and remove the (ICS) screen module from the instrument panel bezel.
scientia non olet · About LEMON Manuals