5.7L / 6.4L

WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electrical Connector, Sensor & Water Pump Housing

Courtesy of CHRYSLER GROUP, LLC

Apply MOPAR® thread sealant with PFTE to the sensor threads.
Install the coolant temperature sensor (2) into water pump housing.
Tighten the coolant temperature sensor to 11 N.m (8 ft. lbs.).
Connect the coolant temperature sensor electrical connector (3).
Install air intake system. Refer to BODY, AIR CLEANER, INSTALLATION or BODY, AIR CLEANER, INSTALLATION, 5.7L or BODY, AIR CLEANER, INSTALLATION .
Replace any lost engine coolant. Refer to STANDARD PROCEDURE .