Diagnostic Test

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

INTERMITTENT DTC
1. Using the scan tool, record and erase the RF Hub DTCs.
2. Turn the ignition off.
3. Arm the Vehicle Theft and Security System (VTSS) and wait one minute.
4. Disarm the VTSS by using the FOBIK.
5. Turn the ignition on.
6. Wait one minute.
7. Using the scan tool, read the active RF Hub Module DTCs.
  Does the scan tool display; B2254-COLUMN LOCK MODULE INTERNAL?
  
  Yes
  - Go To 2.
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and poor pin fit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
PERSONALIZE STEERING COLUMN LOCK MODULE
1. With the scan tool, erase the DTCs in the RF Hub Module.
2. With the scan tool, perform the Steering Wheel Lock Module (ELV) "Replaced routine".
3. Turn the Ignition off, wait 15 seconds then turn the ignition back on.
4. Press the ignition switch on and off several times then leave the Key-In Ignition Node (KIN) in the run position.
5. With the scan tool, read the DTCs.
  Does the scan tool display: B2254-COLUMN LOCK MODULE INTERNAL?
  
  Yes
  - Replace the Steering Column Lock Module in accordance with the service information. The Radio Frequency Hub (RF Hub) must also be replaced along with the Steering Column Lock Module (ELV). When replacing the RF Hub and the Steering Column Lock Module (ELV), the RF Hub MUST be programmed BEFORE the Steering Column Lock Module (ELV) is programmed. .
  - Replace and program the Radio Frequency Hub (RF Hub) in accordance with the Service Information. Refer to MODULE, RADIO FREQUENCY (RF HUB), REMOVAL .
  - Replace and program the Steering Column Lock Module (ELV) in accordance with the Service Information. Refer to MODULE, SHAFT LOCK, REMOVAL .
  - Perform the RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST. Refer to RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST .
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .