Front Driveshaft (AWD)
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Install driveshaft (1) into position.NOTE:
Driveshaft bolts must be replaced with NEW or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied.
- Starting at the transfer case end, align the index marks made during removal and install the driveshaft to transfer case flange bolts (2) hand tight.
- Align the index marks at the front axle end of the driveshaft, and install the driveshaft to front axle flange bolts (2) hand tight.
- Torque the driveshaft to transfer case and driveshaft to axle flange bolts (2) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the crossmember, the crossmember bolts (1) and the transmission mount bolts (2) and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS
.
- Remove the transmission jack (1).
- Remove the support and lower the vehicle.