5.7L And 6.4L
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disconnect the negative battery cable before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage the electrical system.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.CAUTION:
Do not let the tensioner arm snap back to the freearm position, severe damage may occur to the tensioner.
- Rotate the accessory drive belt tensioner clockwise until it contacts the stop and remove the accessory drive belt, then slowly rotate the tensioner into the freearm position.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the belly pan. Refer to BELLY PAN, REMOVAL .
- Depress the field wire connector tab at the rear of the generator and disconnect the field wire harness connector.
- Remove the insulator cover from B+ output terminal at the rear of the generator.
- Remove the B+ terminal retaining nut at the rear of the generator and remove the B+ terminal.
- Remove the generator support bracket to engine mount retaining nut (1).
- Remove the generator support bracket retaining bolt (2) and remove the support bracket (3).
- Remove the remaining lower generator retaining bolt.
- Remove the support and lower the vehicle.
- Remove the upper generator retaining bolt (1) and remove the generator (2) from the vehicle.