LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Automatic CVT, CVT2L >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (3.6L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Left >> Removal

Insulator, Engine Mount, Left: Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
    GC0144028Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
    GC0144029Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Inlet Air Temperature (IAT) sensor wire harness connector (1).
  4. Loosen the clamp (2) at the throttle body.
  5. Loosen the clamp (3) at the air cleaner housing.
  6. Lift the air inlet hose assembly retaining grommet off the ball stud (4).
  7. Remove the air inlet hose assembly (5).
    GC0144614Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Left engine mount shown in illustration, right engine mount similar.

  8. Remove the left engine mount isolator heat shield retaining nuts (3) and remove the heat shield (4).
  9. Remove both left and right engine mount isolator to frame retaining bolts (2).
  10. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0095584Courtesy of CHRYSLER GROUP, LLC
  11. Remove retainers (1) and the belly pan.
  12. Using a suitable screw jack, raise the engine to gain clearance for engine mount isolator removal.
    GC0144622Courtesy of CHRYSLER GROUP, LLC
  13. Remove the engine mount bolts (1) and the engine mount isolator (2).
  14. If required, remove the left engine mount bracket retaining bolts and remove the left engine mount bracket.
scientia non olet · About LEMON Manuals