Dual Pane Sunroof Or Sunshade
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not attempt to move or reposition the sunroof glass panel, the sunshade or the drive cables with the sunroof or sunshade motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.
WARNING:
The Sunroof Initialization and Obstacle Detection Calibration procedure must be completed any time a sunroof or sunshade motor and module unit is replaced with a new component or existing motor is removed and re-installed onto sunroof module. Failure to perform these procedures may result in damage to the vehicle, to the sunroof, to the sunshade or in serious or fatal injuries.
- Position the sunroof or sunshade motor (4) to the sunroof frame.
- Install and tighten the Dual Pane Sunroof or Sunshade Motor Mounting Screws (2). Tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
- Connect the wiring harness connector (3).
- Install the headliner to the inner roof panel (1). Refer to HEADLINER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- If a previously initialized sunroof or sunshade motor was installed, perform the Dual Pane Sunroof Or Sunshade Override Position Calibration procedure. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .
- If a new sunroof or sunshade motor was installed, perform the Sunroof Motor And Module Initialization procedure. Refer to MOTOR, SUNROOF, STANDARD PROCEDURE .