Valve, Short Runner: Installation: Installation

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rubber O-Ring Seal

Courtesy of CHRYSLER GROUP, LLC

NOTE:

When the SRV actuator is removed, a new rubber O-ring seal must be installed. The old O-ring cannot be reused.

Install a new SRV actuator rubber O-ring seal (1).

Fig 2: Short Runner Valve (SRV) Actuator Retaining Bolts & SRV Actuator
Courtesy of CHRYSLER GROUP, LLC
Position the SRV actuator (2), install the retaining bolts (1) and tighten to 5 N.m (44 in. lb.).

Fig 3: Intake Manifold And Throttle Body
Courtesy of CHRYSLER GROUP, LLC
Install the intake manifold and throttle body as an assembly. Refer to MANIFOLD, INTAKE, INSTALLATION or MANIFOLD, INTAKE, INSTALLATION, 5.7L or MANIFOLD, INTAKE, INSTALLATION .

Fig 4: Negative Battery Cable
Courtesy of CHRYSLER GROUP, LLC
Connect the negative battery cable (1).