LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Automatic CVT, CVT2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 330 (Starting System (Service Information)) >> Starter >> Removal >> 3.7L

Section 330 (Starting System (Service Information)): Starter: Removal: 3.7L

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate negative battery cable.
  2. Raise and support vehicle.
  3. Four Wheel Drive Equipped:  Remove front propeller shaft.
    Fig 1: Starter Heat Shield - 3.7L
    GC0085946Courtesy of CHRYSLER GROUP, LLC
  4. Remove two heat shield bolts (1) and remove starter heat shield (2).
    Fig 2: Solenoid Nut, Mounting Stud, Electrical Connector & Battery Cable Assembly
    GC0082153Courtesy of CHRYSLER GROUP, LLC
  5. Remove solenoid nut (1) from mounting stud (3).
  6. After nut (1) has been removed, pull battery cable from mounting stud (3) while removing electrical connector (5) from solenoid terminal.
    Fig 3: Starter Motor - 3.7L
    GC0085947Courtesy of CHRYSLER GROUP, LLC
  7. Remove two starter mounting bolts (1).
  8. Remove starter assembly (2) from transmission.
  9. Rotate starter assembly to allow removal from vehicle.
scientia non olet · About LEMON Manuals