Section 27 (Starting System (Service Information)): Starter: Removal: 3.7L

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate negative battery cable.
Raise and support vehicle.
Four Wheel Drive Equipped: Remove front propeller shaft.

Fig 1: STARTER HEAT SHIELD - 3.7L
Courtesy of CHRYSLER LLC
Remove two heat shield bolts (1) and remove starter heat shield (2).

Fig 2: ELECTRICAL CONNECTION - STARTER MOTOR
Courtesy of CHRYSLER LLC
Remove solenoid nut (1) from mounting stud (3).
After nut (1) has been removed, pull battery cable from mounting stud (3) while removing electrical connector (5) from solenoid terminal.

Fig 3: STARTER MOTOR - 3.7L
Courtesy of CHRYSLER LLC
Remove two starter mounting bolts (1).
Remove starter assembly (2) from transmission.
Rotate starter assembly to allow removal from vehicle.