LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Automatic CVT, CVT2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Power Windows (Service Information)) >> Motor, Window Regulator >> Removal >> Removal

Motor, Window Regulator: Removal: Removal

WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Motor And Gear Assembly & Interior Trim Panel
GC0144825Courtesy of CHRYSLER GROUP, LLC
  1. Partially raise or lower the door glass to relieve tension on motor and cables where possible. Secure the glass as necessary.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the door interior trim panel (2). Refer to PANEL, DOOR TRIM, REMOVAL or PANEL, REAR DOOR TRIM, INSTALLATION and PANEL, REAR DOOR TRIM, POLICE, INSTALLATION for the appropriate procedure.
    Fig 2: Window Motor
    GC0144826Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the power window motor electrical connector (3) from the motor electrical connector receptacle.
  5. Remove the three fasteners (2) that secure the power window motor and gear assembly (1) to the carrier plate.
    Fig 3: Identifying Cable Drive And Motor
    GC0139229Courtesy of CHRYSLER GROUP, LLC
  6. Using a suitable flat bladed tool, lightly pry the cable drive (1) away from the motor (2) and remove the motor and gear assembly.
scientia non olet · About LEMON Manuals