LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Limited, AWD, Automatic CVT, CVT2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 191 (Electronic Control Modules (Service Information)) >> Module, Heated Seat >> Installation >> Installation

Module, Heated Seat: Installation: Installation

WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Properly align the Heated Seat Module (HSM) retaining tabs to the bracket, prior to engagement. Failure to follow these instructions may result in damage to the HSM.

Fig 1: Electrical Connectors, Heated Seat Module, Retaining Tab & Bracket
GC0144580Courtesy of CHRYSLER GROUP, LLC
  1. Position the Heated Seat Module (HSM) (1) to the bracket (4) and engage the two front retaining tabs (2). Make sure the front retaining tabs are correctly engaged to the bracket.
  2. Engage the rear HSM retaining tab (5). Make sure the rear retaining tab is fully engaged to the bracket.
  3. Connect the electrical connectors (3) to the HSM.
  4. Install the seat. Refer to SEAT, FRONT, INSTALLATION .
  5. Reconnect the negative battery cable.
  6. Verify proper heated seat system operation.
scientia non olet · About LEMON Manuals