Electronically Controlled Clutch: Installation: Installation

Fig 1: Electric Clutch At Rear Axle

Courtesy of CHRYSLER GROUP, LLC

1. Apply RTV to the EEC mounting surface.
2. Install wave washer.
3. Slide ECC into rear axle.
4. Install the four ECC mounting bolts and tighten to 68 N.m (50 ft. lbs.).
5. Plug the electrical connector (3) in.
6. Connect the breather hose to EEC.
7. Install the EEC Harness routing bracket bolt and tighten to 14 N.m (124 in. lbs.).
8. Install the rear propeller shaft. Refer to INSTALLATION .
9. Install the exhaust system. Refer to MUFFLER, EXHAUST, INSTALLATION .