LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Compass Latitude, 2.4 B, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 380 (Electronic Control Modules (Service Information)) >> Module, Intrusion Transceiver >> Installation >> Installation

Module, Intrusion Transceiver: Installation: Installation

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Motion Sensor Connector
GC0146812Courtesy of CHRYSLER GROUP, LLC
  1. Position the Intrusion Transceiver Module (ITM) (2) into the mount integral to the overhead console housing. Be certain that all of the latch features are fully engaged
  2. Reconnect the intrusion module sensor pigtail wire harness connector (1) to the ITM.
    Fig 2: Front Overhead Console
    GC0146811Courtesy of CHRYSLER GROUP, LLC
  3. Reinstall the overhead console into the headliner. Refer to CONSOLE, OVERHEAD, INSTALLATION .
  4. Reconnect the negative cable to the battery. If equipped with an Intelligent Battery Sensor (IBS), reconnect the IBS connector.
scientia non olet · About LEMON Manuals