Switch, Speed Control: Installation: Installation
WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Refer to WARNING . Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Position the Speed Control switch pod to the back of the steering wheel armature.
- Install and tighten the three screws (one front (1), two back) securing the speed control switch bezel to the steering wheel armature.
- Connect the wiring harness to the speed control switch bezel.
- Install the remote radio switch. Refer to SWITCH, REMOTE RADIO, INSTALLATION .
- Install the air bag. Refer to AIR BAG, DRIVER, INSTALLATION .
- Connect the negative battery cable.