Section 111 (Starting System (Service Information)): Starter: Installation: 3.6L
WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Starter Solenoid Electrical Connector, Solenoid Stud, Starter Mounting Bolts & Starter Assembly
- Position the starter (3) inside the transmission.
- Install the starter mounting bolts (4) and tighten to 55 N.m (41 ft. lbs.).
- Connect the starter solenoid electrical connector (1) to starter solenoid terminal.
- Install the battery cable and nut to the solenoid stud (2). Tighten the nut to 11 N.m (97 in. lbs.).
- Install the starter solenoid heat shield.
- Install the steering gear lower intermediate shaft (1). Refer to SHAFT, INTERMEDIATE, LOWER, INSTALLATION or SHAFT, INTERMEDIATE, UPPER, INSTALLATION .
- Remove the steering wheel holder.
- Connect the negative battery cable and tighten nut to 5 N.m (4.5 in. lbs.).