Section 110 (Charging System (Service Information)): Generator: Removal: 3.0L

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover

Courtesy of CHRYSLER GROUP, LLC

Disconnect the negative battery cable.
Remove the engine cover (1).

Fig 2: Three Push Pins & Lower Splash Shield
Courtesy of CHRYSLER GROUP, LLC
Remove the right front wheel and tire assembly. Refer to REMOVAL .
Remove the three push pins (1) and the lower splash shield (2).

Fig 3: Lower Generator Bolt, Nut, Ground Cable & Stud
Courtesy of CHRYSLER GROUP, LLC
Lower the vehicle.
Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
Remove the lower generator bolt (4).
Remove the nut (2) the ground cable (1), and stud (3) from the bottom of generator.

Fig 4: Field Generator Wire Harness Connector, Protective Cover, Two Upper Bolts, Generator & B+ Cable
Courtesy of CHRYSLER GROUP, LLC
Disconnect the field generator wire harness connector (3).
Remove the protective cover (1) from the B+ cable (6).
Remove the two upper bolts (5) and the generator (4).