Steering System: Gear: Installation: Installation

Fig 1: Mounting Bolts

Courtesy of CHRYSLER GROUP, LLC

Install the steering gear on the frame rail and tighten the bolts (1) to 118 N.m (87 ft. lbs.)

Fig 2: Pitman Arm Nut
Courtesy of CHRYSLER GROUP, LLC
Align and install the pitman arm (2) and tighten the nut (3) to 251 N.m (185 ft. lbs.).

Fig 3: Track Bar Frame Side
Courtesy of CHRYSLER GROUP, LLC

NOTE:

It may be necessary to pry the axle assembly over to install the track bar (1) at the frame rail.

Install the track bar at the frame rail bracket.
Install the nut and bolt (2) at the frame rail bracket and tighten to 169 N.m (125 ft. lbs.).
Remove the support and lower the vehicle.

Fig 4: Lower Coupling AT Gear
Courtesy of CHRYSLER GROUP, LLC
Align the column coupler shaft (1) to the steering gear (2). Install a new coupler pinch bolt and tighten to 49 N.m (36 ft. lbs.).

Fig 5: Steering Gear
Courtesy of CHRYSLER GROUP, LLC
Install the power steering hoses/tubes (1, 2) to the steering gear (3) and tighten to 36 N.m (27 ft. lbs.).
Reinstall the coolant bottle back into position.
Fill the power steering system to the proper level. Refer to STANDARD PROCEDURE .
Check the toe setting. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .