Fuel System Pressure Release Procedure
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear seat cushion cover. Refer to COVER, SEAT CUSHION, REAR, REMOVAL
.
- Remove the fuel pump module cover.
- Disconnect the electrical connector (2) from the main fuel pump module (1).
- Start and run the engine until it stalls.
- Attempt restarting the engine until it will no longer run.
- Turn the ignition key to the OFF position.
- Disconnect and isolate the negative battery cable.
- One or more Diagnostic Trouble Codes (DTC's) may have been stored in PCM memory. The scan tool must be used to erase a DTC.