Ignition Switch
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure the ignition switch is in the RUN position and the actuator shaft in the lock housing is in the RUN position.CAUTION:
Use care when installing the ignition switch on the lock cylinder housing to avoid damaging the key-in plunger (3).
- Align the ignition switch with the key-in plunger (3), actuator shaft and retaining tabs (2) located on the lock cylinder housing. Carefully install the switch, snapping it into place over the retaining tabs.
- Install the ignition switch (2) mounting screw (1). Tighten the screw to 2 Nm (18 lbf-in).