Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- AWD CONTROL MODULE VERIFICATION TEST
- Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
- With the scan tool, select Clear Stored DTCs.
- Make sure that all accessories are turned off and that the battery is fully charged.
- Test drive the vehicle and verify proper operation.
- With the scan tool, select View DTCs in the AWD Control Module.
Are there any DTCs present in the AWD Control Module?
Yes
- Refer to Diagnosis and Testing and perform the appropriate diagnostic test.
No
- Repair is complete.