Diagnostic Test

CONFIGURE THE INTRUSION TRANSCEIVER MODULE
1. Using the scan tool under miscellaneous functions perform the initialization procedure for the Intrusion Transceiver Module.
2. With the scan tool, clear DTCs.
3. Turn the ignition off and remove the key from the ignition.
4. Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
5. Disarm the VTSS.
6. Using the scan tool, read DTCs.
  Does the DTC reset?
  
  Yes
  - Replace the Intrusion Transceiver Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .