Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR TIPM CAN BUS DTCS
- With the scan tool, read TIPM DTCs.
Are there any TIPM CAN BUS DTCs present?
Yes
- Refer to Diagnosis and Testing and perform the appropriate diagnostic procedure.
- Refer to Standard Procedure and perform AWD Control Module VERIFICATION TEST.
No
- Go To 2.
- With the scan tool, read TIPM DTCs.
- CHECK IF CLUSTER/CCN DTCS ARE PRESENT
- With the scan tool, read CLUSTER/CCN DTCs.
Are there any CLUSTER/CCN DTCs present?
Yes
- Refer to Diagnosis and Testing and perform the appropriate diagnostic procedure.
- Refer to Standard Procedure and perform AWD Control Module VERIFICATION TEST.
No
- Using the schematics as a guide, check the AWD Control Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the AWD Control Module in accordance with the Service Information.
- Refer to Standard Procedure and perform AWD Control Module VERIFICATION TEST.
- With the scan tool, read CLUSTER/CCN DTCs.