3.8L Engine

Fig 1: WATER PUMP SEAL

Courtesy of CHRYSLER LLC

1 - WATER PUMP HOUSING

2 - SEAL

3 - IMPELLER

Install new seal (2) into water pump housing groove.
NOTE: The water pump pulley MUST be positioned loosely between the pump housing and drive hub BEFORE water pump installation.
Position the water pump pulley loosely between pump housing and drive hub.

Fig 2: Gasket And Water Pump
Courtesy of CHRYSLER LLC
Install the water pump (1), new gasket (1) and pulley to the timing chain case cover. Tighten the water pump bolts (2) to 12 N.m (105 in. lbs.).
Position pulley on water pump hub. Install bolts and tighten to 28 N.m (250 in. lbs.).
Rotate pump by hand to check for freedom of movement.
Install the accessory drive belt. See Cooling/Accessory Drive/BELT, Serpentine - Installation
Install drive belt shield.
Evacuate air and refill cooling system. See Cooling/Engine/PUMP, Water - Standard Procedure
Check cooling system for leaks. See Cooling - Diagnosis and Testing