LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2010 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition Control (Service Information) >> SENSOR, Camshaft Position, 2.8L Diesel >> Removal >> Diesel

SENSOR, Camshaft Position, 2.8L Diesel: Removal: Diesel

  1. Disconnect and isolate the negative battery cable.
    Fig 1: CMP Location
    GC0082158Courtesy of CHRYSLER LLC

    2. The Camshaft Position Sensor (CMP) (3) is located at the front/top of the cylinder head.

  2. Remove electrical connector from CMP sensor (3).
  3. Clean area at base of sensor.
  4. Remove sensor mounting bolt (1) and washer (2).
  5. Pull sensor (3) straight up for removal.
scientia non olet · About LEMON Manuals