LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2010 >> Patriot Limited, EDG, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Rear Driveline Module) >> SEAL, Output Flange >> Installation >> Installation

SEAL, Output Flange: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: SEAL ONTO INSTALLER
GC0083901Courtesy of CHRYSLER LLC
  1. Place the seal on the installer.
    Fig 2: INSTALL/REMOVE PINION SIDE SEAL
    GC0083902Courtesy of CHRYSLER LLC
  2. Install the pinion side seal using Installer 9893 and Handle C-4171.
  3. Install right side halfshaft. Refer to Differential and Driveline/Half Shaft - Installation .
    Fig 3: SEAL ONTO INSTALLER
    GC0083901Courtesy of CHRYSLER LLC
  4. Place the seal on the installer.
    Fig 4: INSTALL/REMOVE RING GEAR SIDE SEAL
    GC0083903Courtesy of CHRYSLER LLC
  5. Install the ring gear side seal using Installer 9893 and Handle C-4171.
  6. Install left side halfshaft. Refer to Differential and Driveline/Half Shaft - Installation .
  7. Fill RDA as needed. See Differential and Driveline/Rear Driveline Module - Standard Procedure .
  8. Lower vehicle and road test.
scientia non olet · About LEMON Manuals