Second Row Center And Right Outboard
WARNING:
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar ® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Position the center and right seat belt buckle unit (2) between the second row seat cushions (10).
- Position the lower anchor of the seat belt buckle unit to the inboard side of the right center seat bracket (7). Be certain that the anti-rotation tab on the anchor is engaged in the notch of the bracket.
- Install and tighten the screw (6) that secures the buckle anchor to the right center seat bracket. Tighten the screw to 55 N.m (41 ft. lbs.).
- Lower the front edge of the seat cushions downward and align the seat cushion legs (8) to the holes in the rear floor panel (9).
- Install and tighten the four screws (1) that secure the legs to the floor panel. Tighten the screws to 54 N.m (40 ft. lbs.).